Jeep Comanche MJ 3D-printable parts

Console cupholder adapted specifically for Comanche MJ interiors with the parking brake on the floor. Two variants provide standard beverage wells, a small-can recess, and side slots for cards or change.

Replacement hood-prop rod holder for RENIX-era Cherokee XJ and Comanche MJ vehicles. The creator does not claim fitment on 1997–2001 Cherokees.

Small and large replacement caps for exposed interior trim screws in a Jeep Comanche MJ, including the larger fastener above the dome lamp. The source documents the physical prints and installed fit in several trim locations.

Solid replacement cap for the engine-bay relay cover used on 1984–1996 Cherokee XJ and Comanche MJ vehicles. Use a high-temperature material.

Oval firewall grommet for the 4.0L engine-control harness in 1984–1996 Cherokee XJ and Comanche MJ vehicles. Print in a suitable flexible, heat-resistant material.

Dimensionally matched replacement blank for unused dashboard switch openings in 1984–1996 Cherokee XJ and Comanche MJ interiors.

Clock-delete panel for a Cherokee XJ or Comanche MJ dashboard that accepts one 52 mm gauge and two rocker switches.

Replacement transfer-case shift-indicator plate and insert for the floor console used in Cherokee XJ and Comanche MJ vehicles. The blank surface can be lettered or backlit.

Clock-delete switch panel developed on a 1989 Comanche MJ and stated by the creator to fit the Cherokee XJ dashboard. Blank and pre-drilled switch layouts are included.

Replacement retaining clip for the 2.5-litre airbox. The creator trial-fitted nylon prints on a 1990 vehicle, road-tested them and explicitly identifies the matching Comanche application.