Tools — 3D-printable Jeep parts

Replacement key/tool for operating the Jeep Renegade MySky removable roof panel. Minor filing may be needed to tune the fit for a particular printer.

Reinforced hand wrench for removing and installing the H11 headlight bulb in a 2015 Grand Cherokee WK2's confined lamp housing. The selected version is the physically tested hand-tool geometry; the source warns that the bulb turns only one quarter turn.

Socket-style service wrench for the 74.5 mm, 14-flute oil-filter housing used by the 2007–2008 Grand Cherokee WK and WH with the 3.0L CRD diesel engine. The creator designed it from measured filter geometry and documented a physical test print.

Hand tool for releasing the fuel-line quick connector on a 2005 Cherokee KJ or Liberty KJ.

Purpose-built wrench for removing a seized Cherokee XJ fuel-pump retaining ring without striking the ring with a hammer and screwdriver.

Reinforced 24 mm socket for the Pentastar oil-filter housing used in Wrangler JK models. This V2 geometry accepts either a 3/8-inch or 1/2-inch drive; the creator tested the earlier PLA version to the 25 N·m service torque.

Hand wrench for loosening and tightening Wrangler JK Freedom-panel knobs without straining fingers. Two grip profiles are included.

Protective clips that snap over the lower edges of removed TJ doors before they are set on concrete or sand.