Exterior — 3D-printable Jeep parts

Upper and lower flexible bushings for mounting the front grille to the body on late-1970s Jeep CJ-5 and CJ-7 vehicles. Flat- and recessed-upper variants plus the lower bushing are included for TPU printing.

Two-piece front-bumper retainer modeled from the fastener on a 2000 Grand Cherokee WJ. The creator verified the installed function and oriented the insert for layer strength.

Replacement slotted insert modeled from a surviving 1997–2001 Cherokee XJ grille insert. The creator recommends minor scaling if required for the individual grille.

Replacement captive screw-nut insert for the Cherokee XJ front grille. The creator recommends PETG or ABS for service temperature and durability.

Replacement door-speaker grille for full-size Jeep doors. The source photograph compares the printed grille with the surviving factory grille frame.

Insert used in pairs to fill the license-plate mounting holes in an AEV rear bumper before the plate screws are installed on a Wrangler JL.

Replacement end cap for the stock 1997–2006 Wrangler TJ front bumper. Two copies complete the bumper.

Replacement end cap for the stock 1997–2006 Wrangler TJ rear bumper. The creator test-fitted the design on a European-market TJ.

Bracket for relocating a winch-controller jack into a grille slot. Exact grille spacing should be checked before drilling or wiring; speculative CJ and TJ fitment was not assigned.