Jeep Cherokee / Liberty KJ / Liberty 3D-printable parts

Multi-piece snap-in center cap modeled for the approximately 55–56 mm wheel opening on a 2004 Jeep Liberty KJ. This entry uses the creator's plain top and excludes the decorative lettered top.

Replacement brackets and spacers that support the pop-up air dam on the sliding Sun-Rider roof fitted to a Jeep Liberty KJ. The creator modeled them from the original parts and used the printed set successfully.

Replacement louvre linkage arm and five blade profiles for repairing the dashboard air vents in a 2005 Jeep Liberty KJ. The submitted meshes preserve the source geometry while reducing excessive tessellation for the API.

Hand tool for releasing the fuel-line quick connector on a 2005 Cherokee KJ or Liberty KJ.

Reinforced replacement sun-visor clip for a Jeep Liberty KJ. This revision adds a small retention bump so the visor clicks securely into the clip.

Dashboard pod for two auxiliary gauges in a Cherokee KJ or Liberty KJ. It fits without drilling or cutting the instrument panel.

Replacement fader-control knob for the factory radio in a Jeep Liberty KJ. The creator recommends a heat-resistant material suitable for a parked vehicle interior.

Replacement retaining clip for the windshield defrost vent in a Jeep Liberty KJ dashboard.

Replacement rear cargo-area tie-down loop for a 2005 Jeep Liberty KJ, developed after the original riveted loop was damaged during carpet removal. The source includes installed validation photographs.

Replacement center fin for a broken dashboard air vent in a 2003 Jeep Liberty KJ. The creator notes that the end pins may require light sanding for fit.

Removable coin cup and riveted docking adapter shaped for the Jeep Liberty KJ center console. The cup is sized for US coins.