Jeep Grand Cherokee ZJ / ZG 3D-printable parts

Rigid MOLLE/PALS panel for the 1996–1998 Grand Cherokee ZJ center console. Standard and no-spacer versions are included, with the installation sequence and finished use documented.

Replacement transfer gear and pressure roller for the Grand Cherokee ZJ power-antenna drive. The creator installed the pair after the worn mechanism rattled and failed to extend fully.

Replacement strain-relief shell for the neutral-safety-switch electrical connector on a 1998 Grand Cherokee ZJ.

Replacement link between the HVAC blend-door actuator and lever on a 1998 Grand Cherokee ZJ.

Replacement square peg for the Grand Cherokee ZJ headlight-adjustment mechanism.

Bolt-on bracket developed for mounting a three-inch auxiliary light above the front fender of a Grand Cherokee ZJ. The source documents the installed bracket from three angles.

Socket tool for removing the lower outer headlight adjuster on 1993–1998 Grand Cherokee ZJ assemblies.

Replacement sun-visor retaining clip designed and used on a Grand Cherokee ZJ after the factory clip failed.

Replacement headlight closure-panel lock ring modeled for a 1996 Grand Cherokee ZJ. The creator identifies possible use across the 1993–1998 generation.

Service funnel sized for the 19 mm automatic-transmission fill tube on a Grand Cherokee ZJ. Small sealing rings are included in the printed geometry.

Push-fit center cap modeled for 1993–1998 Grand Cherokee ZJ wheel hubs. The source includes an installed result and recommends PETG with supports.

Radio fascia for adapting a single-DIN head unit to the factory radio opening in Grand Cherokee ZJ and export-model ZG dashboards. Locating pins reproduce the original mounting position.

Blank replacement panel for the 1993–1998 Grand Cherokee ZJ Vehicle Information Center or Graphic Display Module opening. The panel provides a clean base for switches, gauges, or ports.

Segmented inserts that replace the missing extruded-rubber strips in the stainless cargo-floor moldings of a Grand Cherokee ZJ. The segments are sized for a compact printer and conceal their joints after installation.

Replacement passenger-side interior release handle developed for a circa-1994 Grand Cherokee ZJ and installed in the vehicle. A heat-resistant cabin material and high infill are recommended.

Replacement roller for the scissor-type window regulator used in the Grand Cherokee ZJ. Three rollers service one regulator; the creator documents heat-assisted installation over the original ball-ended pins.

Strengthened upper clip that retains the Grand Cherokee ZJ headlight reflector to its vertical adjuster. The source covers the full 1993–1998 ZJ range and documents the load-oriented print position.

Replacement cupholder insert shaped for the Grand Cherokee ZJ center console.

Threaded replacement hood-height stop measured from the original on a 1993 Grand Cherokee ZJ. The creator installed the part and recommends an under-hood material rather than PLA.

Replacement push button for the exterior door-opening handle on a 1998 Grand Cherokee ZJ.

Replacement drive gear for a failed power-seat motion axis in a 1997 Grand Cherokee ZJ. The creator installed the printed gear after removing the broken original and documents the repaired mechanism.

Replacement internal link that joins the driver-door window-switch button to its contact pins on a Grand Cherokee ZJ.

Replacement control knob for a missing power-window switch on a 1997 Grand Cherokee ZJ. The creator iterated the fit and reports that the final geometry works correctly.