Interior — 3D-printable Jeep parts

Replacement passenger-side interior release handle developed for a circa-1994 Grand Cherokee ZJ and installed in the vehicle. A heat-resistant cabin material and high infill are recommended.

Replacement roller for the scissor-type window regulator used in the Grand Cherokee ZJ. Three rollers service one regulator; the creator documents heat-assisted installation over the original ball-ended pins.

Soft slip-on window-sill armrest for a Gladiator JT door card. The flexible pad remains in place while the door and window operate, and its low profile is documented in installed and uninstalled physical views.

Replacement driver-side lock and unlock rocker for 2005–2010 Grand Cherokee WK and WH door-switch panels. It reuses the original spring and metal spring cap; the creator reverse-engineered and tested it from the failed factory button.

Door-corner pod for installing the creator's specified aftermarket tweeter in a 1997–2001 Cherokee XJ. Confirm tweeter diameter before printing.

Solid replacement knob for the manual window crank on a 1993 Cherokee XJ. The creator omitted the weak pre-cut shaft opening so the crank pin forms its own tight fit during installation.

One-piece rigid replacement for a torn Wrangler JK front-door mesh pocket. Mirror the model in the slicer for the opposite door.

Replacement clip that secures the interior door-handle release cable on Wrangler JK doors. The creator recommends a heat-resistant, slightly flexible material.

Springless replacement for the failure-prone upper soft-door window latch, measured from the factory part and installed on the creator's Wrangler.

Full replacement interior release handle modeled after the TJ original. The creator installed the design and reported it still working after approximately nine months.

Driver- and passenger-side replacement handles for paddle-style doors. The creator tested the design in a 1981 CJ-7 and states YJ and TJ compatibility, while warning that earlier non-paddle doors differ.

Replacement clip that retains a door latch push rod. It was modelled from an intact original and the creator reports that it clipped correctly into the door.