Interior — 3D-printable Jeep parts

Replacement drive gear for a failed power-seat motion axis in a 1997 Grand Cherokee ZJ. The creator installed the printed gear after removing the broken original and documents the repaired mechanism.

Jeep Commander mounting set for attaching a compatible MOLLE organizer panel behind a front seat. The set includes the headrest bracket, lower connector, and retaining pin; M4 x 35 mm screws and 5 mm elastic cord complete the installation.

Replacement actuator plug for the Jeep Commander rear-seat release lever. Without the plug the seat release does not operate; the printable geometry directly replaces the discontinued original component.

Replacement center-armrest plug with an opening for a charging module, designed for a 2015 Jeep Compass. Source photos document the printed part, its armrest installation, and the charging-module fit.

Snap-on flashlight holder for the factory front-seat track in Wrangler JL and Gladiator JT vehicles. It installs without drilling and the source documents both the printed clamp and its physical fit.

Protective ring for the power-seat lumbar switch used in 2011 and 2014 Grand Cherokee WK2 interiors. It prevents accidental adjustment while reaching into the vehicle and mounts around the existing control with double-sided tape.

Replacement outer cover for the front-passenger seat-belt anchor on a 2008 Grand Cherokee WK or WH. The source includes the factory part, printed geometry, and physical fit views.

Replacement trim bezel around the front-seat folding lever in a two-door Cherokee XJ. The same geometry fits either seat side.

Replacement shim for a missing rear-seat hinge pin isolator on a 1989 Cherokee XJ.

Replacement bushing that removes play from the tilting passenger-seat slide mechanism on the 2002 Wrangler TJ.

Exact-replica replacement foot for the removable rear bench seat, modeled from the part in a 2000 Wrangler Sport and designed to reuse the original embedded washer and screw.