Jeep Grand Cherokee WJ / WG 3D-printable parts

Two-piece replacement for the ashtray and accessory-socket panel in 1999–2004 Grand Cherokee WJ and WG center consoles. The layout supports five Carling switches, two seat-heater switches, and five accessory sockets while reusing the factory metal latches.

Replacement cupholder for Grand Cherokee WJ and WG center consoles. Moving the cup openings rearward adds a small forward storage pocket; the creator verified the fit in a 2004 vehicle.

Dashboard fascia blank for fitting a double-DIN radio to a Grand Cherokee WJ or export-model WG. The user cuts the final opening for the chosen head unit; the source documents the installed fit.

Replacement fuse-puller tool stored at the Grand Cherokee WJ and WG fuse panel. The source documents both the factory storage position and the printed replacement.

Replacement interior hood-latch release handle developed for a 2001 Grand Cherokee WJ and WG after the factory handle broke.

Replacement receptacle for the ball studs on 1999–2004 Grand Cherokee WJ and WG headlight housings. Three receptacles support each lamp while preserving adjustment movement.

Replacement wing handle for the spare-tire retainer used in 1999–2004 Grand Cherokee WJ and WG cargo areas. The print captures a standard M10 × 1.5 hex nut.

Two-piece floor plug and hose fitting for the Grand Cherokee WJ and WG sunroof drain. The source documents installation with RTV or silicone sealing at the body joint.

Two-piece front-bumper retainer modeled from the fastener on a 2000 Grand Cherokee WJ. The creator verified the installed function and oriented the insert for layer strength.

Replacement sun-visor mounting clip for 1999–2004 Grand Cherokee WJ and WG interiors. The creator reports a perfect fit and provides the printable mesh alongside the original CAD.

Repair insert for a failed P21W bulb socket in Grand Cherokee WJ and WG tail-lamp circuit boards. The source documents the replacement cartridge and wired installation.

Removable sizing sleeve for the oversized driver-side cup opening in a 2004 Grand Cherokee WJ or WG. It supports a standard 20-ounce drink bottle and was test-printed in PETG.

Replacement diffuser modeled from the original under-hood service lamp on a Grand Cherokee WJ or WG.

Replacement pivot pin for the Grand Cherokee WJ and WG heater-core door mechanism. The source specifies solid horizontal printing for strength and alignment with the actuator motor.

Flexible replacement stop for the fuel-filler door on a Grand Cherokee WJ or WG.

Replacement wheel center cap for the Grand Cherokee WJ and WG. This entry uses the creator's rebuilt Fusion geometry rather than the heavier original scan mesh.